#Chamberlain clicker keypad programming how to#

Remember, the LED light must stop flashing before each press of the remote control button. Repeat this process until you hear the opener click, the opener light flashes, or the garage door starts moving. Wait until the LED on the remote control stops flashing, and then press and release the button on the remote that you’re programming to the opener.Press and release the button on the Clicker remote control you want to operate the garage door opener.Locate the learn button on the motor unit, usually on the backside.Press and hold the program button for approximately 2 seconds until the LED lights turn on.You will see the small black program button on the left side and the DIP switch on the right side. Open the remote control’s battery cover by sliding it down.

#Chamberlain clicker keypad programming how to#

Below are the steps on how to program the Clicker remote control. You can program the Clicker remote control to your garage door opener using either the Learn buttons for newer opener models and DIP switches for older opener models. How to program a Clicker garage door remote control We will help you understand how to use the Clicker system and troubleshoot any issues that may arise.

However, often the keypad or remote control will stop working, or you need to program them to the opener, or you forgot the PIN, and you need to reset it. The Clicker keypad and remote controls are a suitable replacement for stock devices and very easy to use. Unfortunately, the Clicker system is only compatible with garage door openers manufactured after 1993, with safety sensors. The Clicker system, manufactured by Chamberlain, makes universal remote controls and wireless keypads that you can program to most garage door openers such as Genie, Chamberlain, LiftMaster Craftsman, and many more, allowing you to operate them.